3 setting up the system, 1 network connection, Setting up the system -7 – Konica Minolta bizhub C200 User Manual
Page 18: Network connection -7
C200
1-7
Overview of printer functions
1
1.3
Setting up the system
In order to use this printing system, it must first be set up.
The setup procedure refers to a series of steps for connecting this machine to a computer and installing the
printer driver on the computer.
The setup procedure consists of the following steps.
1.3.1
Network connection
1
Connect this machine to a computer.
2
Make sure the computer is connected to the network.
3
Specify the IP address of the machine to connect it to the network.
4
Depending on the connection method and protocol, change the network settings of this machine.
–
LPR: Enable the LPD settings in the TCP/IP Setting screen.
–
Port9100: Enable the RAW port setting in the TCP/IP Setting screen, and specify the RAW port
number (default setting is "9100").
–
SMB: Enable "Print Setting" in the SMB Setting screen.
–
IPP/IPPS: Enable IPP print in the IPP Setting screen.
–
AppleTalk: Enable AppleTalk in the AppleTalk Setting screen.
5
Install the printer driver.
–
Specify the network port of the printer driver according to the connection method and protocol.
6
Install the screen fonts.
–
The CD-ROM contains the Latin TrueType fonts as screen fonts. The ScreenFont or Screen Fonts
folder in the CD-ROM contains the screen fonts.
–
Install the screen fonts after adding the operating system standard fonts. For details, refer to Help
of the operating system.
–
Macintosh fonts are compressed. Decompress them before installing.
2
Reminder
After installing the printer driver, perform test print to make sure that the connections are made
properly.
!
Detail
For details on applicable interfaces, refer to
"Compatible interfaces" on page 1-6
For details on network settings, refer to the User’s Guide [Network Administrator].
The procedure for installing the printer driver differs depending on the connection method, operating
system of the computer, and printer driver. For details, refer to
"Precautions for installation" on
.
2
Note
To update an existing printer driver, delete the existing printer driver first. For details, refer to
"Uninstalling the printer driver" on page 6-2
If necessary, specify the interface timeout settings in the Utility mode on the control panel. For details,
refer to
.