Konica Minolta bizhub C25 - Manual (Page 284)

Solving Problems with Media Misfeeds 10-23
Solving Problems with Media Misfeeds
d
Frequent misfeeds in any area indicate that area should be checked,
repaired, or cleaned. Repeated misfeeds may also happen if you’re
using unsupported print media or original media.
Symptom Cause Solution
Several
sheets go
through the
machine
together. The front edges of
the media are not
even. Remove the media and even up the
front edges, then reload it.
The media is moist
from humidity. Remove the moist media and replace
it with new, dry media.
Media mis-
feed mes-
sage stays
on. Front cover needs to
be opened and
closed again to reset
the machine. Open and close the front cover again.
Some media remains
misfed in the
machine. Check the media path again to make
sure that you have removed all of the
misfed media.
Duplex mis-
feeds. Unsupported media
(wrong size, thick-
ness, type, etc.) is
being used. Use KONICA MINOLTA-approved
media. See “Specifications” on
page 3-2.
Also, refer to
http://konicaminolta.com
for a complete list of currently
approved media.
Plain paper, recycled paper, special
paper and thick stock can be autodu-
plexed if the media type is set properly
in the driver. See “Specifications” on
page 3-2.
Make sure that you have not mixed
media types in the tray.
Do not duplex, envelopes, labels, let-
ter head, postcards, glossy media, or
single side only paper.
Media is still being
misfed. Check the media path inside the
duplex again to make sure that you
have removed all of the misfed media.