Konica Minolta bizhub C25 - Manual (Page 189)

Scanning With the Machine 7-10
7
After all document pages have been scanned, press the Start key.
The scanned document is sent to the specified location.
d
If the Stop/Reset key is pressed while scanning, [JOB CANCEL]
appears. To continue scanning, select [NO]. To stop scanning,
select [YES].
d
To cancel a job where scanning was finished and the data is
queued to be sent, refer to “Deleting a Queued Transmission Job”
on page 7-32.
Specifying the Data Location
Select whether the computer or USB memory device is the location where
scan data is to be saved. When transmitting via a network, refer to “Specify-
ing the Destination Address (Scan to E-mail/FTP/SMB)” on page 7-12.
d
If an address has been specified as the destination for the data,
[SCAN TO PC] and [SCAN TO USB MEMORY] cannot be selected.
Saving Data on a Computer Connected (Scan to PC)
Follow the procedure described below to send scan data to a computer con-
nected to this machine.
d
In order to perform this operation, make sure the TWAIN scanner
driver, the printer driver, and LinkMagic (Windows only) have been
installed on your computer.
d
Before performing the Scan to PC operation, be sure that either Link-
Magic is activated or the LinkMagic icon appears in the notification
area.
d
The scan settings specified with LinkMagic are given priority. Specify
the various settings with LinkMagic. For details, refer to the [Refer-
ence Guide] on the Documentation CD/DVD.
d
The Scan to PC operation can be used only if this machine is con-
nected to a computer with a USB cable.
1
In the main screen (Scan mode), press the + or , key to select [SCAN
TO], and then press the Select key.
2
Press the + or , key to select [SCAN TO PC], and then press the Select
key.