Konica Minolta bizhub C25 - Manual (Page 202)

Scanning With the Machine 7-23
4
Use the keypad to type in the number (between 1 and 220) for the speed
dial destination, and then press the Select key.
5
Press the + or , key to select [LDAP SEARCH], and then press the
Select key.
d
If an LDAP server is not specified, [LDAP SEARCH] does not
appear.
6
Press the + or , key to select [NAME] or [E-MAIL], and then press the
Select key.
d
To search registered names, select [NAME]. To search e-mail
addresses, select [E-MAIL].
7
Use the keypad to type in the search keyword (maximum of 10 charac-
ters), and then press the Select key.
The search begins, and the search results appear after a while. If no data
matches the search keyword, [NOT FOUND] appears for about two sec-
onds.
d
For details on entering/editing text, refer to “Entering Text” on
page 12-8.
d
Text starting with the first character of the maximum 10 charac-
ters is searched for. Text will not be found if the search keyword is
in the middle of a word.
8
Press the + or , key to select the desired data, and then press the
Select key.
d
To check the found information, press the ) key.
d
An e-mail address exceeding 64 characters cannot be specified. If
such an e-mail address is specified, [ADDRESS IS TOO LONG]
appears for about two seconds, and then the screen for specify-
ing the destination address appears.
d
To narrow down the search results, press the Back key, and then
perform step 7 again.
9
If desired, edit the registration name, and then press the Select key.
10
If desired, edit the e-mail address, and then press the Select key.
The settings are registered, and the [DIAL REGISTER] menu appears
again.