Rana Systems Elite Series User Manual
Page 44
ELITE SERIES USER MANUAL
DOS ENHANCEMENTS
or, if you’re stuck with a Disk II, type:
0
PROFILE will then ask for the seek speed of the
drive:
ENTER SEEK SPEED (0-2) :
0) SLOW (DISK-II AND ELITE SERIES)
1) MEDIUM (ELITE SERIES ONLY)
2) FAST (ELITE TWO AND THREE)
The “?” in the example will be the “pre-loaded”
answer (default) for the type of drive you spec-
ified on the previous menu. The default will be
the maximum possible seek speed for the drive
model specified. Now is not a good time to
fiddle with seek speeds (you’ll just complicate
matters), so just type:
to use the default.
PROFILE will then update the configuration table
displayed at the top of the screen. It should
now show the correct setting for your system
drive. At the bottom of the table, you will
again get:
ENTER SELECTION (0-3)
1) LOAD NEW DOS IMAGE FROM DISK
2) CHANGE CURRENT DOS IMAGE SETTING
3) SAVE CURRENT DOS IMAGE TO DISK
0) TERMINATE PROFILE
Page 3—19