Rana Systems Elite Series - Manual (Page 212)

ELITE SERIES USER MANUAL ENHANCED DOS UTIL.
DRIVE NUMBER (1-4)?
where is the drive number from which you ran
CLONE.
The also refers to the drive in which you will
he inserting the source diskette. You can
simply press if is correct. If
you wish to specify a different drive number,
press the new number.
After the source drive number, CLONE asks:
DISKETTE TYPE (0-3)?
where is the drive type which you have
specified (using PROFILE) for the source drive
you selected, as follows:
0 = Disk II
1 = Elite One
2 = Elite Two
3 = Elite Three
Although CLONE determines the default answer to
this question by looking to see how you have the
source drive defined under the currently booted
DOS, this question is referring to the source
diskette itself and not the drive.
CLONE places restrictions on both the source
diskette and the destination diskette according
to how the drive is defined under the booted
DOS. CLONE will not permit you to specify a
diskette type which has a larger capacity than
P a g e 9 - 1 5