Cirrus Logic CapturePlus II - Manual (Page 12)

CapturePlus II
12 DS789UM2
USB Communications
A USB communication link must be established between the PC and the CapturePlus II hardware before
the CapturePlus II system can operate.
To open communication to a USB connection perform the following steps:
– Select an available USB device address by double clicking on a USB address within the Detected
Devices sub-panel. The selected address will appear in the Selected Device Address sub-panel,
the Connect USB and Clear Device Address buttons will become available, and the Disconnect
button will be unavailable.
– Click on the Connect USB button. When USB communication is established, the Connected
indicator at the bottom right corner of the screen will become bright green and read “Connected”.
The Connect USB and Clear Device Address buttons will become unavailable. The Disconnect
button will become available.
To close communication to a USB connection perform the following steps:
– Click on the Disconnect button. When USB communication is disconnected, the Connected
indicator will turn gray and read “Disconnected”. The Connect USB and Clear Device Address
buttons will become available.
– To remove a USB device address from the Selected Device Address sub-panel, click on the Clear
Device Address button.
Serial Port Communications
Serial port communications between the PC and the CapturePlus II hardware is NOT required for the Cap-
turePlus II system to operate.