Festo Линейный привод с датчиком перемещения DGPIL - Manual (Page 28)

DGPI(L)−...−AI F
Festo DGPI(L)−...−AIF 0409a English
28
Fitting the electric components
S Wire the earth connection with earth potential.
ć Cable cross sectional area at least 1.5 mm 2 .
ć Cable length max. 10 m.
S Insert the screw with cutting thread (included in delivery) into the hole for
the earth connection 9 (see Fig. 1).
This will guarantee electrical contact despite the anodized coating.
S Wire the measuring system connection together with the control system.
Only the original cable may be used for this purpose (Pin assignment see
Fig. 16).
Measuring system connection PIN Assignment
1 CAN−Low
4 5
2 CAN−High
3
4 5
6
3 n.c.
1 2
3 6
4 n.c.
5 +24 V DC
6 0 V
n.c. = not connected
Fig. 16
Note that the permanent magnet fitted in the piston is only suitable for operating
the integrated measuring system.
Proximity switches with magnetic actuation cannot be used.