elektraLite CP100xt Manual Part One - Manual (Page 64)

64
fine number fine rotary step size, from one to 255. The default is normally one, but is forty
for pan and tilt features, or the maximum feature value if steps is specified. This is the step size
when the rotary is initially turned, not the step size when Fine is turned on; the latter is always one.
Note that if this is set to something greater than one, it also sets coarse (below) to one; if you wish
to set both, coarse must therefore follow fin e.
coarse number ratio of coarse to fine step size, from one to 255. The default is normally ten, but is
set to one if steps or fine is specified. This determines the step size after the rotary has been
turned eight clicks in the same direction. If the rotary is to have a fixed step size, without changing
scaling after it has been turned eight clicks, set
fine to the desired size, and leave coarse equal
to one.
clear number value to set feature to when cleared. The default is zero if the feature name is
Di m, Shu t, Re d, Green or Blu e, off (meaning the feature is unaffected by clearing) otherwise.
clear switch disables the clear function if the switch is off, clears it to zero if it is on.
clear max sets the clear value to the maximum feature value.
clear sets the clear value to zero.
narrow number value to set feature to when narrow Hi-Lited. Narrow Hi-Lite occurs when setting
Stage Focus coordinates. The default value is the maximum value if the feature name is Di m, Shu t,
Re d, Green or Blu e; zero if the feature name is Cya n, Ma g, Ye l, Ef f, Fros t, Pris m, or has Rot
as its 2
nd
through 4th character; or off (meaning the feature is unaffected by Hi-Lite) otherwise.
narrow switch disables narrow highlighting if the switch is off, sets the feature’s narrow high-
lighting
value to its maximum value if it is on.
narrow max sets the feature’s narrow highlighting value to its maximum value.
narrow sets the feature’s narrow highlighting value to zero.
wide number value to set feature to when wide highlighted. It has the same defaults and variations
as narro w.
hilite number Sets both narrow and wid e. It has the same defaults and variations as narro w.
steps numbers list of feature values on which the rotary stops, and which can be addressed with
the Color or Gobo command. The default is none. See below for details.
The explanations above indicate that there are certain feature names that are treated specially:
Pa n, Tilt pan or tilt is turned on.