elektraLite CP100xt Manual Part One - Manual (Page 62)

62
type string the name of the fixture type, up to fourteen characters.
For example: Miniscan
stage switch yes if the fixture supports stage focus. If this isn’t specified, the default is ye s,
although if the fixture type doesn’t have both pan and tilt features, it has no effect. If a fixture type
has
pan and tilt features and this is on, the attribute list includes the Stage Focus coordinates P0 0,
P0 1, P1 0, P1 1, T0 0, T0 1, T10 and T1 1.
stage equivalent to stage of f.
scale number the ratio between the scaling of the coarse pan or tilt feature to the fine, for high-
resolution steer-able fixtures. The range is 2 to 256, and the default is 256. This is ignored if the
fixture doesn’t have high-resolution pan and tilt features. Next, the features are listed, in order of
physical channel. Each feature is represented by any combination of the following optional parameters
in any order, except that the first one must be the
channel parameter which names it. No two
channels may have the same name.
channel string the name of the feature corresponding to this fixtures DMX channel, up to five
characters.
For example: color, gobo, iris, prism, etc.
short switch yes if the feature’s maximum value is 100, no if it is 255. The default is yes if
the feature is called Di m, no otherwise. If the feature is pan or tilt, its maximum value is 9999
regardless of this. Use this if your dimmer channel will be labeled something other than “dim”.
short toggles the short parameter. That is, it sets the feature’s maximum value to 255 if it is
called Di m, 100 otherwise.
master number zero if the feature is unaffected by the Grand Master fader, nonzero if it is scaled
by the fader. The fader scales the output only if its DMX value (on a zero to 255 scale, before scaling)
would be less than or equal to this value. Thus, it should be 255 for most dimmers, or 128 for the split
feature on some fixtures that acts like a dimmer from zero to 128, and then strobes beyond that point.
The default is 255 if the feature is called
Di m, zero otherwise.
master disables master control if the feature is called Di m, enables it over the full range otherwise.
fos switch yes if the full feature range corresponds to a DMX output range of 15 to 255, instead of
the usual zero to 255. This is a special mode used for some FOS fixtures; its default value is n o. If this
is specified without a switch, it is turned on.
fos equivalent to fos ye s. htp switch yes if HTP, no if LTP. The default is yes if the
feature name is Di m, Shu t, Re d, Green or Blu e, no otherwise.
htp toggles the HTP parameter.