Hubbardton Forge 306603 User Manual

B274, Installation instructions

H U B B A R D T O N F O R G E . C O M

hand-forged, vermont-made lighting and accessories

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

27824 Rev A

Installation Instructions

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

Please Note: This fixture is designed to be mounted on a standard wall

surface and may not be suitable for all applications. If installing in a non-

wood frame application, we recommend consulting a qualified builder

or electrician.

To Mount Fixture to Wall

(Figures 1 & 2)

Component Parts

A Fixture Assembly

B Wall Mount Bracket

C Anchors (4)

D #10 Screws (4)

E #8 Black Screws (4)

F Rubber Washer (2)

G Green Ground Screw

H Cupped Washer

I Caulking Lip

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.

1. Carefully unpack the fixture from the carton.

2. Center the wall mount bracket (B) over the electrical box

being sure to hold it plum and level. With a pencil, mark the

location of all mounting holes in the wall mount bracket on

the wall behind.

Important: Wall mount bracket must be secured to a solidly

mounted electrical box and/or a framing member in at least

two locations. Do not depend on drywall anchors alone to

support this fixture. If in doubt, contact a qualified electrician. Put
the wall mount bracket down and drill 1/4" holes in the locations

marked on the wall. For holes using anchors, place the tapered end
of the anchors (C) into the holes and gently tap them flush to the

wall using a light weight hammer.

3. Thread the wires in the electrical box through the center

hole in the wall mount bracket while moving the bracket

into position. Using the #10 screws (D), screw the bracket

securely to the wall. Be careful not to over-tighten or

strip the anchors.

B274

Pluto Outdoor Sconce 306603

Page 1 of 3

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

(Figure 1)

(Continued)

C
H

B
D
A
E

(Figure 2)