A125, Assembly & installation instructions – Hubbardton Forge 126503 User Manual

Page 3

H U B B A R D T O N F O R G E . C O M

hand-forged, vermont-made lighting and accessories

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

19909

Assembly & Installation Instructions

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

(Figure 3)

To Install Shade and Glass

(Figure 4)

Component Parts

O Knurl Ball (2)

P Shade Assembly

Q Threaded Studs (2)

R Hex Nut (2)

S Socket Assembly

1. Thread hex nut (R) onto threaded stud (Q) approximately
1/2" from the end.

2. Thread two threaded studs (Q) into socket assembly (S) to
a height of 2 3/8” from top of the socket assembly. Hex
nuts should be at the end closest to the socket assembly.

3. Tighten hex nut (R) against socket assembly (S) until snug.

4. Raise shade assembly (P) past socket assembly (S) until it
clears threaded studs (Q).

5. Align holes in shade assembly (P) with threaded studs (Q)
and lower until it rests on top of socket assembly (S).

6. Thread knurl ball (O) onto threaded stud (Q) and tighten until
snug against the top of shade assembly (P).

7. Restore electricity at main breaker box.

A125

For Exos Semi-Flush 126503

Page 3 of 3

(Figure 4)