Hubbardton Forge 217740 - Manual

Assembly & Installation Instructions
B156
For Ono Sconce 21-7740F Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 21357
Please Note: This fixture is designed to be mounted on a standard wall surface and may not be suitable for all
applications. If installing in a non-wood frame application, we recommend consulting a qualified builder or electrician.
Prepare to Install (Figures 1 & 2)
Component Parts
A Fixture
B Fixture
Front
C 8-32 x 3/8” Black Screws (2)
D Wall Mounting Bracket
E 8-32 x 1 ¼” Screws (3)
Caution: Be sure power is off at the main breaker box prior to installation.
1. Carefully unpack the fixture from the carton.
2. Remove two screws (C) (top and bottom) holding fixture front (B) to fixture (A).
3. Place fixture front (B) and screws (C) somewhere safe for later use.
4. Remove three screws (E) from front of fixture (A) to release wall mounting bracket (D).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1) (Figure 2)