A122, Assembly & installation instructions – Hubbardton Forge 19453010 User Manual
Page 2

Assembly & Installation Instructions
A122
For Compass Chandelier 19-453010 & 19-453610
Page 2 of 3 _
Hand-Forged,
Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
19895 Rev A
Install the Threaded Rods
(Figure 2)
Component Parts
J Plug
K Hex Nut (4)
L Loop
Assembly
M Threaded Rod (4)
1. Slip bent end of threaded rod (M) through holes in loop assembly (L).
2. Thread hex nut (K) onto threaded rod (M) until bottomed out and snug.
3. Lower threaded rod (M) until hex nut (K) sits flat inside loop assembly (L).
4. Install plug (J) in holes of loop assembly (L) to cover hex nut (K).
To Install Glass Frame and Glass
(Figure 3)
Component Parts
M Threaded Rod (4)
N Glass
O Tab
P Threaded Ball (4)
Q Glass
Frame
1. Slip tabs on glass frame (Q) onto three threaded rods (M)
and attach with threaded ball (P).
2. Slip glass (N) into glass frame (Q) so it rests below the
three tabs.
3. Slip tab (O) onto last threaded rod (M) and slide onto glass
frame (Q).
4. Thread threaded ball (P) onto threaded rod (M).
5. Install light bulbs (not provided).
(Figure 3)
(Figure 2)
(continued)