Hubbardton Forge 18453 User Manual
A259, Assembly & installation instructions

Assembly & Installation Instructions
A259
For Adjustable Mobius Shade Pendant 18-453
Page 1 of 7
Hand-Forged,
Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
24794 Rev A
Stem Assembly
(Figure 1)
Component Parts
A Fixture
Pipe
B Fixture
Coupling
1. Carefully unpack the fixture from the carton.
2. Carefully thread fixture pipe (A), threaded end first, over fixture wires.
3. Apply a drop of the supplied thread locking compound to the internal threads of the
fixture coupling (B) and screw stem into fixture, being careful not to twist the wires.
Note: Application of the thread locking compound is necessary to prevent the stem
from loosening during regular maintenance and cleaning of the fixture. Be certain to
apply the compound.
4. See instructions below to complete the installation.
Prepare the Canopy
(Figure 1)
Component Parts
C Jam
Nut
D Crossbar
E Threaded
Nipple
F Canopy
G Canopy
Ring
Caution: Be sure power is off at the main breaker box prior to installation.
1. Thread jam nut (C) and crossbar (D) onto threaded nipple (E); leave both parts loose.
2. Using two machine screws (not provided), temporarily fasten the crossbar (D) to the
electric box.
Note: A new electric box comes with screws. When replacing a fixture,
retain the existing screws for use with the new fixture.
3. Adjust the length of threaded nipple (E) in crossbar (D) so that canopy ring (G) will
hold canopy (F) against the ceiling with no threads showing for best appearance. When
the correct adjustment is established, tighten jam nut (C) against crossbar (D) to hold
the adjustment.
4. Remove the crossbar and stem from the electrical box and proceed with the assembly
instructions.
(continued)
(Figure 1)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)