Hubbardton Forge 18305 - Manual (Page 2)

Installation Instructions
A296
Flora Pendant 18-305 Page 2 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 26973
5. Slide the canopy pipe (F) as far as necessary to give you the total length of the fixture which you desire. Be careful
not to scratch the pipe surfaces and to pull excess wire up through the canopy pipe (F). There must be a minimum
1-1/2" of inner pipe inside the outer pipe. Hand-tighten the clutch to temporarily hold this adjustment. The clutch is
not securely fastened at this point; do not depend on it to hold the fixture.
Important: To ensure full connection strength, be sure the tapered end of the plastic clutch sleeve is oriented
toward the clutch when assembled and securely tighten set screw (Figure 2).
6. Using two machine screws (not provided), fasten the crossbar to
the electric box.
Note: A new electric box comes with screws. When replacing a
fixture, retain the existing screws for use with the new fixture.
7. Using suitable wire connectors (not provided) connect fixture
wires to supply (white to white or ribbed and black to black or
smooth). Run a pigtail lead from crossbar ground screw (K) to the
junction box and connect all ground wires (bare copper or green
to bare copper or green).
Caution: Make sure wire connectors are twisted on securely, and
no bare wire is exposed.
8. Slide fixture canopy (D) against ceiling, and secure with canopy
ring (E).
9. Once the fixture is fastened to the ceiling, tighten the set screw (J)
firmly with hex wrench provided. Only after the set screw (J) is
tight should the glass be installed.
10. Refer to instructions below to install glass and light bulb.
(continued)
(Figure 3)