Hubbardton Forge 18305 - Manual

Installation Instructions
A296
Flora Pendant 18-305 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 26973
Prepare the Canopy (Figure 1)
Component Parts
A Jam Nut (2)
B Crossbar
C Threaded
Nipple
D Canopy
E Canopy
Ring
Caution: Be sure power is off at the main breaker box prior to installation.
1. Thread jam nut (A) and crossbar (B) onto threaded nipple (C); leave parts
loose. Note: Fixture comes with two jam nuts but in most cases only one is
needed.
2. Using two machine screws (not provided), temporarily fasten the crossbar
(B) to the electric box. Note: A new electric box comes with screws. When
replacing a fixture, retain the existing screws for use with the new fixture.
3. Adjust the length of threaded nipple (C) in crossbar (B) so that canopy ring
(E) will hold canopy (D) against the ceiling with no threads showing for best
appearance. When the correct adjustment is established, tighten jam nut (A)
against crossbar (B) to hold the adjustment.
4. Remove the crossbar and stem from the electrical box and proceed with the assembly instructions.
Complete Assembly & Install Fixture
(Figures 2 & 3)
Component Parts
D Canopy
E Canopy
Ring
F Canopy Pipe
G Fixture Pipe
H Plastic Sleeve
I Clutch
J Set
Screw
K Ground Screw
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Place canopy (D) over canopy pipe (F), followed by canopy
ring (E). Make sure smaller diameter side of canopy ring is
oriented up toward the canopy.
2. Carefully slide canopy ring (E) and canopy (D) down over fixture pipe
(G) until they rest on the fixture
3. Thread wires from the fixture pipe (G) through the canopy pipe (F).
4. Unscrew the clutch (I) from the canopy pipe (F); slide it across the wires and onto the fixture pipe (G). Follow this
with the plastic clutch sleeve (H), oriented so the tapered end of the clutch sleeve nests in the clutch (Figure 2).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)