Hubbardton Forge 137725 - Manual (Page 4)

Assembly & Installation Instructions
A313
Erlenmeyer Pendant 137725 Page 4 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 27331
8. Using suitable wire connectors (not provided) connect fixture wires to supply (white to white and black to black).
Using cupped washer (O) and green ground screw run pigtail from mounting bracket (J) to junction box. Connect all
ground wires, including fixture ground wire. Push wires back into outlet box.
Caution: Make sure wire connectors are twisted on securely, and no bare wire is exposed.
9. Raise fixture (F) to ceiling over threaded studs (Q) and push firmly to ceiling, making sure that no wires are pinched
between canopy and ceiling. Secure the canopy by attaching knurled balls (R) then threading #8 screws (M) through
the ends of the canopy into the threaded holes in the bracket (J).
Note: Be sure both swivel notches are aligned in the
same direction. For sloped ceilings the notches should
face towards the down side.
10. Once the fixture is fastened to the ceiling, tighten the
clutch set screws (I) firmly with hex wrench provided.
Only after the set screws (I) are tight should you install
the glass.
11. Continue with glass and bulb installation below.
To Install Glass (Figure 7)
Component Parts
T Bulb
U Glass
V Thumb Screw
1. Install bulb (T). Be careful not to touch bulb with bare hands; oil from the hands
will dramatically reduce bulb life.
2. Loosen the three thumb screws (V). It is not necessary to remove them from the
fixture.
3. Raise glass (U) until groove is aligned with thumb screws (V).
4. Tighten the three thumb screws (V) equal amounts until snug with glass (U).
Be careful not to over tighten.
5. Repeat steps 1 thru 4 for all five lights.
6. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 6)
(Figure 7)