A329, Assembly & installation instructions – Hubbardton Forge 137680 User Manual

Page 4

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

H U B B A R D T O N F O R G E . C O M

hand-forged, vermont-made lighting and accessories

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

28118

Assembly & Installation Instructions

Install Diffuser

(Figures 10 & 11)

Component Parts

K Hex Nut (2)

P Diffuser

S Stud (2)

T Fender Washer (2)

U Rubber Washer (2)

V Triangular Tip (2)

5. Assemble Diffuser. Align diffuser (P) so that shaped notch

fits around lower forged element (O). Locate 2 Triangular tip

assemblies shipped assembled, each made up of a nut (K),

stud (S), fender washer (T), rubber washer (U) and triangular

tip (V). Unscrew nut (K) and set aside. Unscrew stud (S)

from triangular tip (V). Fasten one triangular tip assembly

to each end of glass diffuser (P) as shown. Rotate stud (S)

to tighten until rubber washer (U) is gently clamping diffuser

glass against diffuser tip (V). Do not over-tighten. (Figure

10).

6. Install diffuser. Once the diffuser (P) is built up with the tip

assemblies it is ready to install. Lift Diffuser Assembly from

bottom so shoulders on top of studs (S) rest against under

side of fixture (F). Secure with nuts (K). (Figure 11).

7. Restore electricity at the main breaker.

A329

Stream Pendant 137680

Page 4 of 4

(Figure 10)

(Figure 11)

K
S

SHAPED NOTCH