Hubbardton Forge 137720 - Manual

Assembly & Installation Instructions
A276
Erlenmeyer 4-Light Pendant 13-7720 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 26494
To Assemble Canopy (Figure 1)
Component Parts
A .38” Hex Nipple (2)
B .50” Hex Nipple(longer) (2)
C Lock Washer (4)
D Canopy
E Canopy Pipe (4)
F Ceiling
Bracket
1. Carefully unpack canopy from carton.
2. Line up end of canopy pipe (E) with hole in canopy (D).
3. Place hex nipple (A) through lock washer (C), down through
holes in canopy (D) and thread into canopy pipe (E). Tighten
securely. Repeat twice.
4. Place longer .50” hex nipple (B) through lock washer (C),
down through holes in ceiling bracket (F) and canopy (D)
thread into canopy pipe (E). Tighten securely. Repeat twice.
To Assemble Fixture (Figures 2 & 3)
Component Parts
D Canopy
E Canopy Pipe (4)
G Fixture pipe (4) H Clutch sleeve (4)
I Clutch
(4)
J Set Screw (4)
1. Slip the wires from the fixture pipe (G) into and through the
canopy pipe (E) up through the canopy (D).
2. Unscrew the clutch (I) from the canopy pipe (E); slide it across
the wires and onto the fixture pipe (G). Follow this with the
plastic clutch sleeve (H), oriented so the tapered end of the
clutch sleeve nests in the clutch (Figure 2). Slide the canopy pipe
(E) as far as necessary to give you the total length of the fixture
which you desire. Be careful not to scratch the pipe surfaces and to
pull excess wire up through the canopy pipe (E). Screw clutch (I)
onto canopy pipe (E). There must be a minimum 1-1/2" of inner pipe inside the outer pipe. Hand-tighten the clutch
to temporarily hold this adjustment. The clutch is not securely fastened at this point; do not depend on it to hold the
fixture.
Important: To ensure full connection strength, be sure the tapered end of the plastic clutch sleeve is
oriented toward the clutch when assembled and securely tighten set screw (Figure 2). Stop. Please see installation
instructions on next page.
3. Once the fixture is fastened to the ceiling, tighten the set screw (J) firmly with hex wrench provided. Only after the
set screw (J) is tight should you install the glass.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)
(Figure 1)