A262, Assembly & installation instructions – Hubbardton Forge 137660 User Manual

Page 2

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

H U B B A R D T O N F O R G E . C O M

hand-forged, vermont-made lighting and accessories

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

24824 Rev B

Assembly & Installation Instructions

To Complete Fixture Assembly

(Figure 3 & 4)

Component Parts

A Fixture Pipe (2)

C Hex Nipple

F Canopy Pipe (2)

G Clutch (2)

CAUTION: BE SURE POWER IS OFF AT THE MAIN BREAKER BOX
PRIOR TO INSTALLATION.

1. Thread wires from the fixture pipe (A) through canopy (J).
Slide canopy (J) down fixture pipe (A) until it rest on top of
fixture.

2. Thread the wires from the fixture pipe (A) into and through
the canopy pipe (F) up through the hex nipple (C).

3. Unscrew the clutch (G) from the canopy pipe (F); slide it
across the wires and onto the fixture pipe (A). Follow this
with the plastic clutch sleeve (H), oriented so the tapered
end of the clutch sleeve nests in the clutch (Figure 3).

4. Slide the canopy pipe (F) as far as necessary to give you
the total length of the fixture which you desire.
Be careful not to scratch the pipe surfaces and to pull
excess wire up through the canopy pipe (F). Screw clutch
(G) onto canopy pipe (F). There must be a minimum 1-1/2"
of inner pipe inside the outer pipe. Hand-tighten the clutch
to temporarily hold this adjustment. The clutch is not se
curely fastened at this point; do not depend on it to hold the
fixture.

Important: To ensure full connection strength, be sure the tapered
end of the plastic clutch sleeve is oriented toward the clutch when
assembled and securely tighten set screw (Figure 3).

5. Continue with Ceiling Installation below.

A262

Brindille Pendant 137660 & Twofold Pendant 137640

Page 2 of 4

LARGE DIAMETER PIPE

PLASTIC CLUTCH SLEEVE

(Figure 3)

H Plastic Clutch Sleeve (2)

I Set Screw (2)

J Canopy

(Continued)

CLUTCH

(Figure 4)

This manual is related to the following products:

137640