beautypg.com

A176, Assembly & installation instructions – Hubbardton Forge 136753 User Manual

Page 2

background image

Assembly & Installation Instructions

A176

Impressions Adjustable Pendant 13-6753

Page 2 of 3

Hand-Forged, Vermont-Made Lighting and Accessories

154 Route 30 South, Castleton, Vermont 05735

21362 Rev C

3. Thread wires from the fixture pipe (A) through the canopy pipe (J).

4. Unscrew the clutch (L) from the canopy pipe (J); slide it across the wires

and onto the fixture pipe (A). Follow this with the plastic clutch sleeve (K),
oriented so the tapered end of the clutch sleeve nests in the clutch
(Figure 3).

5. Slide the canopy pipe (J) as far as necessary to give you the total length of

the fixture which you desire. Be careful not to scratch the pipe surfaces and
to pull excess wire up through the canopy pipe (J). There must be a
minimum 1-1/2" of inner pipe inside the outer pipe. Hand-tighten the
clutch to temporarily hold this adjustment. The clutch is not securely
fastened at this point; do not depend on it to hold the fixture.

Important: To ensure full connection strength, be sure the tapered end of
the plastic clutch sleeve is oriented toward the clutch when assembled and
securely tighten set screw (Figure 3).

6. Carefully slide canopy ring (I) and canopy (H) down over fixture pipe (A)

until they rest on the fixture.

7. Using two machine screws (not provided), fasten the crossbar to the

electric box.

Note: A new electric box comes with screws. When replacing a fixture,
retain the existing screws for use with the new fixture.

8. Using suitable wire connectors (not provided), connect fixture wires to

supply wires (white to white supply, black to black supply). Run a pigtail
lead from crossbar ground screw (P) to the junction box and connect all
ground wires (bare copper or green to bare copper or green). Push wires
back into outlet box.

Caution: Make sure wire connectors are twisted on securely, and no bare
wire is exposed.

9. Slide fixture canopy (H) against ceiling, and secure with canopy ring (I).

10. Once the fixture is fastened to the ceiling, tighten the set screw (M) firmly

with hex wrench provided. Only after the set screw (M) is tight should you install the glass.

11. Refer to instructions below to install glass and light bulb.

(continued)

(Figure 3)