Hubbardton Forge 136753 - Manual

Assembly & Installation Instructions
A176
Impressions Adjustable Pendant 13-6753 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 21362 Rev C
Prepare the Canopy (Figure 1)
Component Parts
E Jam Nut (2)
F Crossbar
G Threaded Nipple
H Canopy
I
Canopy Ring
Caution: Be sure power is off at the main breaker box prior to installation.
1. Thread jam nuts (E) and crossbar (F) onto threaded nipple (G); leave parts loose.
2. Using two machine screws (not provided), temporarily fasten the crossbar (F) to the
electric box. Note: A new electric box comes with screws. When replacing a fixture,
retain the existing screws for use with the new fixture.
3. Adjust the length of threaded nipple (G) in crossbar (F) so that canopy ring (I) will
hold canopy (H) against the ceiling with no threads showing for best appearance.
When the correct adjustment is established, tighten jam nuts (E) against crossbar (F)
to hold the adjustment.
4. Remove the crossbar and stem from the electrical box and proceed with the assembly
instructions.
Complete Assembly & Install Fixture (Figures 2 & 3)
Component Parts
A Fixture Pipe
H Canopy
I
Canopy Ring
J Canopy Pipe
K Plastic Sleeve
L
Clutch
M Set Screw
N Top Diffuser
O Socket Assembly
P Ground Screw
Caution: Be sure power is off at the main breaker box prior to
installation.
1. Place canopy (H) over canopy pipe (J), followed by canopy ring (I). Make
sure smaller diameter side of canopy ring is oriented up toward the canopy.
2. Slip diffuser (N) over fixture pipe (A) until it rests on top of socket assembly (O).
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 2)
(Figure 1)