Hubbardton Forge 136510 - Manual (Page 3)

Assembly & Installation Instructions
A324
For Corona Triple Canopy Pendant 13-6510 Page 3 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 28099 Rev A
(Figure 5)
12. Thread included jam nut onto canopy nipple (R).
13. Thread canopy nipple (R) into canopy (I) center hole and tighten jam nut to prevent the nipple from spinning.
14. Install canopy cover (K) on canopy nipple (R).
15. Thread the lock up (L) on to canopy nipple (R). Tighten against canopy cover (K) until snug.
16. Refer to instructions below to install glass.
To Install Glass and Bulb (Figure 5)
Component Parts
S Socket (12)
T Bulb (Included)(12)
U Glass (12)
1. Install light bulbs (T). Be careful
not to touch bulb with bare hands;
oil from the hands will dramatically
reduce bulb life.
Note: The bulb included is based
on our design preference; see the
fixtures wattage sticker for Max
wattage information
.
2. Slip glass (U) over socket (S) and
thread until snug against socket. Be
careful not to over tighten.
3. Repeat for remaining sockets.
4. Restore electricity at the main
breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this
product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.