Hubbardton Forge 136510 - Manual

Assembly & Installation Instructions
A324
Corona Triple Pendant 13-6510 Page 1 of 3
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 28099 Rev A
To Assemble Canopy (Figure 1)
Component Parts
A Hex Nipple (3)
B Lock Washer (3)
C Canopy
D Canopy Pipe (3)
1. Carefully unpack canopy from carton.
2. Line up end of canopy pipe (D) with hole in canopy (C).
3. Place hex nipple (A) through lock washer (B), down through holes in
canopy and thread into canopy pipe. Tighten securely.
4. Repeat steps 2 and 3 for the remaining stems.
Stem Assembly (Figure 2)
Component Parts
E Fixture Pipe (3)
F Fixture Coupling (3)
1. Carefully thread fixture pipe (E), threaded end first, over fixture
wires.
2. Apply a drop of the supplied thread locking compound to the
internal threads of fixture coupling (F) and screw stem into fixture,
being careful not to twist or pinch the wires.
Note: Application of the thread locking compound is necessary to
prevent the stem from loosening during regular maintenance and
cleaning of the fixture. Be certain to apply the compound.
3. Complete steps 1 & 2 for remaining fixture pipes.
4. See instructions below to complete the installation.
(continued)
CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL
INJURY OR DEATH AND PROPERTY DAMAGE. We recommend installation by a licensed electrician.
This product must be installed in accordance with applicable installation code(s), by a person familiar with the
construction and operation of the product and the hazards involved.*
Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.
(Figure 1)
(Figure 2)