Hubbardton Forge 133325 - Manual (Page 3)

Assembly & Installation Instructions
A260
Kirigami Four Light Pendant 13-3325 Page 3 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 24799 Rev A
To Assemble Bottom
(Figures 4, 5 & 6)
Component Parts
L Hex Nut
M Diffuser Top Plate
N Nipple
O Bottom
Assembly
P Shade
Q Threaded Knob (4)
R Threaded Stud (4)
S Diffuser
T Alignment
Pin
U Spring
V Flat Head Screw (4)
1. Remove hex nut (L) (Figure 4). Save for later use.
2. Slip diffuser top plate (M) with flat head screws off
bottom assembly (O) (Figure 4). Save for later use.
3. Install shade (P) into bottom assembly by
slipping the holes in the shade over the threaded
studs (R) (Figure 5).
Note: Be careful when installing shades not to
allow the shade to come in contact with the four
threaded studs. Contact with the studs will
damage the shade and cause visible scratches.
4. Install knobs (Q) to keep shade (P) in place
(Figure 5).
See Figure 6 (next page) for the remaining steps
unless another figure is referenced.
5. Slip diffuser (S) onto nipple (N) aligning the
alignment hole in the diffuser with the alignment
pin.
6. Thread the four flat head screws (V) installed in
the diffuser plate (M) so they protrude slightly
out the bottom of the plate.
7. Align the diffuser top plate (M) so the four flat
head screws (V) align with the four holes in the
diffuser (S) and slip onto the nipple (N) until it
rests on top of the diffuser.
8. Thread hex nut (L) onto nipple (N) until it sits on
top of the diffuser top plate (M). Tighten the hex
nut being careful not to over tighten.
9. Thread the four flat head screws (V) until they are snug.
10. Slip the spring (U) onto the nipple.
11. Refer to instructions following to complete installation.
(continued)
(Figure 4)
(Figure 5)