Hubbardton Forge 133325 - Manual (Page 2)

Assembly & Installation Instructions
A260
Kirigami Four Light Pendant 13-3325 Page 2 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
154 Route 30 South, Castleton, Vermont 05735 24799 Rev A
3. Thread wires from the fixture pipe (H) through the canopy pipe (G).
4. Slide the canopy pipe (G) as far as necessary to give you the total length of
the fixture which you desire. Be careful not to scratch the pipe surfaces and
to pull excess wire up through the canopy pipe (G). There must be a
minimum 1-1/2" of inner pipe inside the outer pipe. Screw clutch (J) onto
canopy pipe and hand-tighten the clutch to temporarily hold this adjustment.
The clutch is not securely fastened at this point; do not depend on it to hold
the fixture.
Important: To ensure full connection strength, be sure the tapered end of
the plastic clutch sleeve is oriented toward the clutch when assembled and
securely tighten set screw (Figure 2).
5. Using two machine screws (not provided), fasten the crossbar to the electric
box.
Note: A new electric box comes with screws. When replacing a fixture,
retain the existing screws for use with the new fixture.
6. Using suitable wire connectors (not provided), connect fixture wires to
supply wires (white to white or ribbed side of the fixture cord, black to black
or smooth side). Run a pigtail lead from crossbar ground screw to the
junction box and connect all ground wires (bare copper or green to bare
copper or green). Push wires back into outlet box.
Caution: Make sure wire connectors are twisted on securely, and no bare
wire is exposed.
7. Slide fixture canopy (D) against ceiling and secure with canopy ring (E).
8. Refer to following instructions to install bulb and shade assembly.
(continued)
(Figure 3)