A194, Assembly & installation instructions – Hubbardton Forge 132205 User Manual
Page 4
Assembly & Installation Instructions
A194
For Four-Light Pendant 13-2205
Page 4 of 4
Hand-Forged,
Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735
22423 Rev A
To Install Double Glass Option
(Figures 7 & 8)
Component Parts
M Socket
(4)
N Bulb
(Included)(4)
Q Harp
(4)
R Washer
(4)
S Retainer
(4)
T
Threaded Stud (4)
U Inner
Glass
V
Threaded Cap (4)
DD
Outer Glass Assembly (Assembled above)(4)
EE
Rubber Stop (12)
1. Install threaded stud (T) into harp (Q) (Figure 7).
2. Install light bulb (N). Be careful not to touch bulb with bare hands; oil
from the hands will dramatically reduce bulb life.
3. Slip outer glass assembly (DD), harp (Q) and washer (R) over
socket (M).
4. Thread retainer (S) onto socket (M) until snug to washer (R).
5. Install rubber stop (EE) to top edge of inner glass (U) equally spaced
around the diameter.
6. Slip inner glass (U) onto threaded stud (T) until it rests against the bottom
of harp (Q).
7. Install threaded cap (V) until snug against the bottom of inner glass (U).
Be careful not to over tighten.
8. Restore electricity at main breaker.
If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased
this product. We hope you enjoy your fixture!
* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.
(Figure 7)
(Figure 8)