Hubbardton Forge 132205 - Manual (Page 2)

Assembly & Installation Instructions
A194
For Four-Light Pendant 13-2205 Page 2 of 4
Hand-Forged, Vermont-Made Lighting and Accessories
P.O. Box 827, 154 Route 30 South, Castleton, Vermont 05735 22423 Rev A
4. Slide canopy (F) over canopy pipe (H) being careful not to scratch finish.
Slide down until the canopy rests against clutch (J).
5. Thread studs (E) through appropriate holes in crossbar (D) to match
holes in canopy (F).
6. Attach crossbar (D) to both canopy pipes (H) using hex nut nipple
(C) and lock washer (L). Note: Be sure both swivel notches are
aligned in the same direction. For sloped ceilings the notches
should face towards the down side.
7. Using two machine screws (not provided), fasten the crossbar (D) to
the electric box. Note: A new electric box comes with screws.
When replacing a fixture, retain the existing screws for use with the
new fixture.
8. Using suitable wire connectors (not provided) connect fixture wires
to supply (white to white and black to black). Connect all ground
wires to green ground screw.
Caution: Make sure wire connectors
are twisted on securely, and no bare wire is exposed.
9. Slide canopy (F) over threaded studs (E) and push firmly to ceiling,
making sure that no wires are pinched between fixture canopy and
ceiling. Fasten with knurled balls (G). Be sure studs are fully
seated in the knurled balls.
10. Refer instructions below and install glass/shade for option
that was purchased.
11. Restore electricity at main breaker.
To Install Shade Option
(Figures 4 & 5)
Component Parts
M Socket (4)
N Bulb (Included)(4)
O Top Diffuser (4)
P Shade (4)
Q Harp (4)
R Washer (4)
S Retainer (4)
T Threaded Stud (4)
U Inner Glass (4)
V Threaded Cap (4)
W Hex Nut (8)
1. Install threaded stud (T) into harp (Q) followed by two hex nuts (W)
(Figure 4).
2. Install light bulb (N). Be careful not to touch bulb with bare hands; oil
from the hands will dramatically reduce bulb life.
3. Slip top diffuser (O), shade (P), harp (Q) and washer (R) over socket (M).
4. Thread retainer (S) onto socket (M) until snug to washer (R).
(continued)
(Figure 4)
(Figure 3)