B296, Installation instructions – Hubbardton Forge 206440 User Manual

Page 2

If you need further assistance, or find that you are missing any parts, please contact the dealer from which you purchased this product.
We hope you enjoy your fixture!

* Hubbardton Forge will not be liable for injury or damage caused by improper installation, lamping or use of this fixture.

H U B B A R D T O N F O R G E . C O M

hand-forged, vermont-made lighting and accessories

154 RT. 30 SOUTH

•

CASTLETON, VERMONT 05735

28808

Installation Instructions

To Install Fixture

(Figures 1 & 2)

(Continued)

4. Thread the wires in the electrical box through the center

hole in the wall mount bracket while moving the bracket into

position. Using the #10 screws (M), screw the bracket

securely to the wall. Be careful not to over-tighten or strip

the anchors.

5. Using two machine screws (not provided) attach mounting

bracket (E) to the electric box using inside oval holes to

orient fixture.

Note: A new electric box comes with screws. When replacing a

fixture, retain the screws for use with the new fixture.

6. Using suitable wire connectors (not provided) connect the

driver (J) wire with the white lead to the white supply wire.

Connect the wire with the black lead to the black supply

wire. Run a pigtail lead from crossbar ground screw (H)

and cupped washer (I) to the junction box and connect all

ground wires (bare copper or green to bare copper

or green).

CAUTION: MAKE SURE WIRE CONNECTORS ARE TWISTED ON
SECURELY AND NO BARE WIRES ARE EXPOSED.

7. Carefully tuck all wires behind the fixture back (C) and inside

the wall mount bracket and place the fixture firmly onto

bracket (E). Fasten with #8 black screws (F) on top and

bottom.

8. Install two countersunk screws (G) through the fixture back

9. Continue with installation instructions following to assemble

fixture front and glass.

B296

Double Axis LED Sconce: 206440D

Page 2 of 4

CAUTION: FAILURE TO INSTALL THIS FIXTURE PROPERLY MAY RESULT IN SERIOUS PERSONAL INJURY OR DEATH AND
PROPERTY DAMAGE. We recommend installation by a licensed electrician. This product must be installed in accordance with
applicable installation code(s), by a person familiar with the construction and operation of the product and the hazards involved.*

Caution: Do not exceed maximum wattage noted on fixture. Use only recommended bulbs with fixture.

(Figure 2)

(Continued)

I
H
K

M
E
C
F

(Figure 2A)