Allied Telesis AT-FS724 - Manual (Page 50)

7UDQVODWHG#6DIHW\#,QIRUPDWLRQ
A-2
RADIATED ENERGY
U.S. Federal Communications
Note: This equipment has been tested and found to comply with the limits for a Class A digital
device pursuant to Part 15 of FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and, if not
installed and used in accordance with this instruction manual, may cause harmful interference
to radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at his own
expense.
Note: Modifications or changes not expressly approved by the manufacturer or the FCC can void
your right to operate this equipment.
Canadian Department of Communications
This Class A digital apparatus meets all requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la classe A respecte toutes les exigences du Réglement sur le matériel
brouilleur du Canada.
'
1 RFI Emission EN55022 Class A
'
2 WARNING: In a domestic environment this product may cause radio interference in which case
the user may be required to take adequate measures.
'
3 Immunity EN50082-1
'
4 Electrical Safety TUV-EN60950, UL1950, CSA 950
'
5 Laser EN60825
At time of installation the Fiber Optic Lasers comply with FDA Radiation Performance Standard
21CFR Subchapter J, applicable at date of manufacture.
'
6 Warning Class 1 Laser product.
'
7 Warning Do not stare into the Laser beam.
'
8 ELECTRICAL NOTICES
WARNING: ELECTRIC SHOCK HAZARD
To prevent ELECTRIC shock, do not remove cover. No user-serviceable parts inside. This unit
contains HAZARDOUS VOLTAGES and should only be opened by a trained and qualified
technician. To avoid the possibility of ELECTRIC SHOCK disconnect electric power to the
product before connecting or disconnecting the LAN cables.
'
9 LIGHTNING DANGER
DANGER: DO NOT WORK on equipment or CABLES during periods of LIGHTNING
ACTIVITY.
'
10 CAUTION: POWER CORD IS USED AS A DISCONNECTION DEVICE. TO DE-ENERGISE
EQUIPMENT disconnect the power cord.
ELECTRICAL—AUTO VOLTAGE ADJUSTMENT
This product will automatically adjust to any voltage between the ranges shown on the label.
'
11 ELECTRICAL—TYPE CLASS 1 EQUIPMENT
THIS EQUIPMENT MUST BE EARTHED. Power plug must be connected to a properly wired
earth ground socket outlet. An improperly wired socket outlet could place hazardous voltages
on accessible metal parts.
'
12 ELECTRICAL—CORD NOTICE
Use power cord, maximum 4.5 meters long, rated 5 amp minimum, 250V, made of
cordage molded IEC 320 connector on one end and on the other end a plug approved by the
country of end use.
WARNING: Only use installed products in the HORIZONTAL position. DO NOT USE
VERTICALLY.
'
13 CAUTION: Air vents must not be blocked and must have free access to the room ambient air for
cooling.
'
14 OPERATING TEMPERATURE
This product is designed for a maximum ambient temperature of 40 degrees C.
'
15 All Countries: Install product in accordance with local and National Electrical Codes.