Allied Telesis AT-S84 - Manual (Page 95)

AT-S84 Management Software User’s Guide
Section I: Using the Menus Interface 95
The LACP Group Status Menu is displayed, as shown in Figure 24.
Figure 24. LACP Group Status Menu
The LACP Group Status Menu displays the following information about
the LACP group:
System Priority
The system priority as defined by IEE 802.3ad. You cannot change
this.
System ID
The MAC address of the system.
Key
The key for this trunk group.
The menu also contains a table that displays the following information:
Aggregator
The port that is operating as the aggregator.
Attached Port List
The ports assigned to the aggregator.
Disabling an
LACP Trunk
To disable an LACP trunk, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 21 on
page 88.
AT-9000/24 Local Management System
Trunk Configuration -> LACP Group Status Menu
System Priority
: 32768
System ID : 00:00:90:24:00:03
Key : 1
Aggregator Attached Port List
----------- -----------------------------
2 2
3 3
4 4
----------------------- -----------------------------
[Q]uit to previous menu
Command>