Allied Telesis AT-S84 - Manual (Page 66)

Chapter 4: SNMP
66 Section I: Using the Menus Interface
The Basic Switch Configuration Menu is shown in Figure 4 on page
32.
2. From the Basic Switch Configuration menu, type N to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 16 on page 63.
3. Type T to select Enable/Disable SNMP Trap Receiver.
The following prompt is displayed:
Set SNMP trap receivers status->Enter entry number>
4. Enter the number of the trap receiver you want to enable or disable.
The following prompt is displayed:
Set SNMP trap receivers status->Enter entry number>
5. Enter the number for the trap you want to enable or disable.
The following prompt is displayed:
Enable or Disable SNMP Trap Receiver (E/D)>
Note
The trap receiver must be one whose status is not “deleted.”
6. Type E to enable the trap receiver or D for disable to disable the trap
receiver.
You can also delete a trap receiver, as described in “Deleting a Trap
Receiver” on page 67
Modifying a Trap
Receiver
To modify a trap receiver, perform the following procedure.
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page
32.
2. From the Basic Switch Configuration menu, type N to select SNMP
Configuration.
The SNMP Configuration menu is shown in Figure 16 on page 63.
3. Type M to select Modify SNMP Trap Receiver.
The following prompt is displayed: