Allied Telesis AT-S84 - Manual (Page 94)

Chapter 6: Port Trunking
94 Section I: Using the Menus Interface
Enter port no>
5. Type the number of the port whose priority you want to set.
The following prompt is displayed:
Enter port priority>
6. Enter a number for the priority of the port.
The range is 1 to 255, and the default is 1.
Verifying the
LACP Group
Settings
To view the LACP group settings, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 21 on
page 88.
2. From the Advanced Switch Configuration Menu, type T to select
Trunk Configuration.
The Trunk Configuration Menu is shown in Figure 22 on page 89.
3. From the Trunk Configuration Menu, type G to select LACP Group
Status.
The following prompt is displayed:
Enter trunk group admin key>
4. Type a number from 1 to 4 to specify the admin key of the trunk you
want to view.