Allied Telesis AT-S84 - Manual (Page 262)

Chapter 22: Virtual LANs
262 Section II: Web Browser Interface
Modifying a VLAN
This procedure allows you to perform the following functions:
ˆ Change the name of a VLAN.
ˆ Add or remove tagged ports from a VLAN.
Before performing this procedure, note the following:
ˆ You cannot change the VID of an existing VLAN.
ˆ You cannot add an untagged port to a VLAN using this procedure.
That function requires changing a port’s VID value, as explained in
“Configuring the PVID of Untagged Ports” on page 258
ˆ You cannot remove an untagged port from a VLAN using this
procedure. To remove an untagged port from a VLAN, you must assign
it as an untagged member of another VLAN by changing its PVID, as
explained in “Configuring the PVID of Untagged Ports” on page 258.
To change the name of a VLAN or to add or remove tagged ports, perform
the following procedure:
1. From the Advanced Config menu, select VLAN Config and then
VLAN Info.
The VLAN Information page is shown in Figure 78.
Figure 78. VLAN Information Page
Use the Next Page and Previous Page buttons to scroll through the
list of VLANs.