Allied Telesis AT-S84 - Manual (Page 50)

Chapter 3: Basic Switch Parameters
50 Section I: Using the Menus Interface
Rebooting the Switch
This procedure reboots the switch and reloads the AT-S84 management
software from flash memory. You might reboot the device if you believe it
is experiencing a problem. Rebooting the device does not change any of
the device’s parameter settings.
Caution
The switch does not forward network traffic during the reboot
process. Some network traffic may be lost.
To reboot the switch, perform the following procedure:
1. From the Main Menu type T to select Switch Tools.
The Switch Tools Configuration Menu is shown in Figure 11.
Figure 11. Switch Tools Configuration Menu
2. From the Switch Tools Configuration Menu, type R to select System
Reboot.
AT-9000/24 Local Management System
Main Menu -> Switch Tools Configuration Menu
Software [U]pgrade...
[C]onfiguration File Upload/Download...
System [R]eboot
[P]ing Execution
[Q]uit to previous menu
Command>