Allied Telesis AT-S84 - Manual (Page 313)

AT-S84 Management Software User’s Guide
Section I: Basic Features 313
VLAN
Configuration
Command Mode
The VLAN Configuration command mode allows you to configure VLAN
commands. To access this mode, you must first access the User EXEC,
Privileged EXEC, and Global Configuration modes. From the Global
Configuration command mode, type:
interface vlan id
The prompt changes to Switch(config-vlan)# to indicate the VLAN
Configuration mode. Then enter VLAN commands.
After you have accessed the VLAN Configuration mode, the commands
you enter apply to the VLAN specified in the Interface Configuration mode.
To configure another VLAN, you must first exit the Interface Configuration
mode and then specify the new VLAN ID in the Global Configuration mode
before returning to the Interface Configuration mode.
See Table 13 for list of commands that can be accessed from the VLAN
Configuration command mode.
Table 13. VLAN Configuration Command Mode Commands
Commands Description
END Exits from the VLAN Configuration mode to the Global
Configuration mode.
EXIT Exits from the VLAN Configuration mode to the Global
Configuration mode.
GETVLAN Displays VLAN ID information.
INTERFACE Changes mode to the Interface Configuration
command mode.
LOGOUT Exits the command line interface and returns to the
Main Menu.
MEMBER Sets a static VLAN member.
MODE Displays the available command modes.
NAME Sets the VLAN name.
NO Negates a command or sets its defaults.
PING Pings a specified IP address to check connectivity to
another system.