Allied Telesis AT-S84 - Manual (Page 43)

AT-S84 Management Software User’s Guide
Section I: Using the Menus Interface 43
Disabling or Enabling the Telnet Server
This procedure describes how to enable or disable the Telnet server on
the switch. The default setting for the Telnet server is enabled,
To disable or enable the Telnet server, perform the following procedure:
1. From the Main Menu, type B to select Basic Switch Configuration.
The Basic Switch Configuration Menu is shown in Figure 4 on page 32.
2. From the Basic Switch Configuration Menu, type I to select User
Interface Configuration.
The User Interface Configuration Menu is shown in Figure 7 on page
38.
3. From the User Interface Configuration Menu, type L to select Enable/
Disable Telnet Server.
The following prompt is displayed:
Enable or Disable Telnet server (E/D)>
4. Type D to disable the Telnet server or E to enable it.