Allied Telesis AT-S84 - Manual (Page 113)

AT-S84 Management Software User’s Guide
Section I: Using the Menus Interface 113
Working with VLANS
This section contains the following procedures:
ˆ “Creating a VLAN,” next
ˆ “Configuring the Port PVID” on page 116
ˆ “Displaying the VLANs” on page 117
ˆ “Modifying a VLAN” on page 119
ˆ “Deleting a VLAN” on page 120
ˆ “Resetting to the Default VLAN” on page 121
Creating a VLAN
This section contains the procedure for creating a new VLAN. This
procedure assigns the VLAN a name, a VID number, and the untagged
and tagged member ports.
After you have performed this procedure, you must configure the untagged
members of the VLAN by adjusting their PVID values to match the virtual
LAN’s VID number. The PVID value of a port must match its virtual LAN’s
VID in order for a port to be considered an untagged member of the VLAN.
This procedure is found in “Configuring the Port PVID” on page 116.
To create a VLAN, perform the following procedure:
1. From the Main Menu, type A to select Advanced Switch
Configuration.
The Advanced Switch Configuration Menu is shown in Figure 21 on
page 88.
2. From the Advanced Switch Configuration Menu, type V to select VLAN
Management.