Allied Telesis AT-2972T/2 - Manual (Page 91)

AT-29xx Series Gigabit Ethernet Adapters Installation Guide
91
The Default is spurious fix = 1 (spurious fix is on).
Choices are:
Spuriousfix=0
Spuriousfix=1 (default).
Poll=
To disable interrupt driven mode in the driver set Poll=1
and the driver will not use interrupts, but will be
polled by the NetWare OS. This is a common feature
supported in NW. The poll mode may increase driver
performance in some environments.
Choices are:
Poll=1 (ON)
Poll=0 (OFF) (default).
WireSpeed=
This feature provides adapter link & data integrity even
when attached to a questionable cable and/or switch.
For example; an adapter trying to run 1000 speed on a
cat3 cable ordinarily would not link. With the
WireSpeed=1, the link will occur at 100Mbs.
Choices are:
WireSpeed=1 (ON) (Default)
WireSpeed=0 (OFF).
Model=
This keyword is to allow the addition of a sub-system ID
of a specific NIC so that the driver loads only on the
first NIC found with a matching sub-system ID.
e.g., MODEl= 0x14e4
Default = 0
MagicP=
When the MagicP=1 the driver will enable the adapter to
wake up the system when a magic packet is received after
the system is shutdown. MagicP=0 is the default setting
with the adapter having no wake up ability.
Choices are:
MagicP=0 (default)
MagicP=1
Fiber=
The driver has support for the 1000FD fiber adapter. The
fiber autonegotiates link with a fiber switch even though
it only supports 1000FD. In some cases the user may want
to force the adapter to 1000FD.
Choices are:
Fiber=AUTO (default)
Fiber=FORCE