Allied Telesis AT-2972T/2 - Manual (Page 62)

Installing Windows 2000 Driver Software
62
which configures the adapter to ignore PAUSE frames.
By default, the Flow Control property is disabled.
To change the Flow Control property, perform the following procedure:
1. Start either a Windows Server 2003 or a Windows XP system and log
in.
You must have Administrator privileges to update the driver software.
2. On the desktop, right click My Computer.
The My Computer window opens.
3. Select Properties from the menu.
The System Properties dialog box opens, as shown in Figure 7 on
page 36.
4. Click the Advanced tab.
The Advanced tab is shown in Figure 13 on page 59.
5. From the Properties list, select Flow Control.
6. From the Values list, select one of the following:
ˆ Auto - (default) PAUSE frame receipt and transmission is
optimized.
ˆ Disable - PAUSE frame receipt and transmission is disabled
(recommended).
ˆ Rx PAUSE - PAUSE frame receipt is enabled.
ˆ Rx/Tx PAUSE - PAUSE frame receipt and transmission is
enabled.
ˆ Tx PAUSE - PAUSE frame transmission is enabled.
7. Click OK.
8. If prompted to restart your computer, click Yes.
Even though it is not necessary to reboot the system for new adapter
properties to take effect, rebooting is recommended to reinitialize all
registers.
9. Verify that the adapter port LEDs operate as described in “LEDs” on
page 19.
Jumbo Mtu
The Jumbo Mtu property allows the adapter to transmit and receive
oversized Ethernet frames that are greater than 1,514 but less than 9,000