Allied Telesis AT-2972T/2 - Manual (Page 133)

AT-29xx Series Gigabit Ethernet Adapters Installation Guide
133
Error Messages
/* 0 */ "PASS",
/* 1 */ "Got 0x%08X @ 0x%08X. Expected 0x%08X",
/* 2 */ "Cannot perform task while chip is running",
/* 3 */ "Invalid NIC device",
/* 4 */"Read only bit %s got changed after writing zero at
offset 0x%X",
/* 5 */ "Read only bit %s got changed after writing one at
offset 0x%X",
/* 6 */ "Read/Write bit %s did not get cleared after writing
zero at offset 0x%X",
/* 7 */"Read/Write bit %s did not get set after writing one
at offset 0x%X",
/* 8 */ "BIST failed",
/* 9 */ "Could not generate interrupt",
/* 10 */ "Aborted by user",
/* 11 */ "Tx DMA:Got 0x%08X @ 0x%08X. Expected 0x%08X",
/* 12 */ "Rx DMA:Got 0x%08X @ 0x%08X. Expected 0x%08X",
/* 13 */ "Tx DMA failed",
/* 14 */ "Rx DMA failed",
/* 15 */ "Data error, got 0x%08X at 0x%08X, expected
0x%08X",
/* 16 */ “Second read error, got 0x%08X at 0x%08X, expected
0x%08X",
/* 17 */ "Failed writing EEPROM at 0x%04X",
/* 18 */ "Failed reading EEPROM at 0x%04X",
/* 19 */ "EEPROM data error, got 0x08X at 0x04X, expected
0x%08X",
/* 20 */ "Cannot open file %s",
/* 21 */ "Invalid CPU image file %s",
/* 22 */ "Invalid CPU image size %d",
/* 23 */ "Cannot allocate memory",