Allied Telesis AT-2972T/2 - Manual (Page 51)

AT-29xx Series Gigabit Ethernet Adapters Installation Guide
51
The System Properties dialog box opens, as shown in Figure 7 on
page 36.
4. Click the Advanced tab.
The Advanced tab is shown in Figure 12 on page 42.
5. From the Properties list, select WOL Speed.
6. From the Values list, select one of the following:
The options are:
ˆ 10 Mb. Sets the speed to 10 Mbit/s. This is the network speed
when the system is in a standby mode awaiting a wake-up frame.
ˆ 100 Mb. Sets the speed to 100 Mbit/s.
ˆ Auto (default). Sets the speed for optimum network connection.
7. Click OK.
8. If prompted to restart your computer, click Yes.
Even though it is not necessary to reboot the system for new adapter
properties to take effect, rebooting is recommended to reinitialize all
registers.
9. Verify that the adapter port LEDs operate as described in “LEDs” on
page 19.