Allied Telesis AT-2972T/2 - Manual (Page 135)

AT-29xx Series Gigabit Ethernet Adapters Installation Guide
135
/* 50 */ "Cannot perform task while chip is not running.
(need driver)",
/* 51 */ "Cannot open register define file or content is
bad",
/* 52 */ "ASF Reset bit did not self-cleared",
/* 53 */ "ATTN_LOC %d cannot be mapped to %cX CPU event bit
%d",
/* 54 */ "%s Register is not cleared to zero after reset",
/* 55 */ "Cannot start poll_ASF Timer",
/* 56 */ "poll_ASF bit did not get reset after
acknowledged",
/* 57 */ "Timestamp Counter is not counting",
/* 58 */ "%s Timer is not working",
/* 59 */ "Cannot clear bit %s in %cX CPU event register",
/* 60 */ "Invalid "EEPROM_FILENAME" file size, expected %d
but only can read %d bytes",
/* 61 */ "Invalid magic value in %s, expected %08x but found
%08x",
/* 62 */ "Invalid manufacture revision, expected %c but
found %c",
/* 63 */ "Invalid Boot Code revision, expected %d.%d but
found %d.%d",
/* 64 */ "Cannot write to EEPROM",
/* 65 */ "Cannot read from EEPROM",
/* 66 */ "Invalid Checksum",
/* 67 */ "Invalid Magic Value",
/* 68 */ "Invalid MAC address, expected %02X-%02X-%02X-%02X-
%02X-%02X",
/* 69 */ "Slot error, expected an UUT to be found at
location %02X:%02X:00",
/* 70 */ "Adjacent memory has been corrupted while testing
block 0x%08x-0x%08x\nGot 0x%08x @ address
0x%08x. Expected 0x%08x",
/* 71 */ "The function is not Supported in this chip",
/* 72 */ "Packets received with CRC error",