Allied Telesis AT-9448Ts/XP (Basic Layer 3) - Manual (Page 88)

Chapter 6: Adding and Removing Switches
88
11 Assign the new switch the stack ID
number of the replaced unit. “Assigning Static Module ID Numbers to the
Member Switches” on page 57
12 Power off the switch by disconnecting
the power cord from the power source
and from the back panel of the unit. --
13 Connect the replacement switch to
the stack by cabling the AT-StackXG
Stacking Module. “Cabling the AT-StackXG Stacking Modules” on
page 60
14 Power on the stack. “Powering On the Switches of the Stack” on
page 63
15 Verify that the stack is operating
properly with the replacement switch. “Verifying the Installation” on page 65
16 If there is a problem, refer to this
section for troubleshooting
suggestions. “Troubleshooting the Discovery Process” on
page 67
17 Connect the network cables to the
ports on the replacement switch. “Cabling the Twisted Pair and Fiber Optic Ports”
on page 74
Table 11. Replacing a Member Switch in a Stack
Task Procedure