Allied Telesis AT-9448Ts/XP (Basic Layer 3) - Manual (Page 31)

31
Chapter 2
Installing the Hardware
This chapter contains an overview of the installation procedures for a stack
and the procedures for installing the hardware. The chapter contains the
following sections:
ˆ “Installation Overview” on page 32
ˆ “Reviewing the Safety Precautions” on page 34
ˆ “Planning the Installation of a Stack” on page 36
ˆ “Maximum Number of Switches in a Stack” on page 37
ˆ “Unpacking a Switch” on page 38
ˆ “Installing the AT-StackXG Stacking Module” on page 39
ˆ “Installing the Power Cord Retaining Clip (AC Switches Only)” on
page 42
ˆ “Disconnecting the Network Cables” on page 43
ˆ “Installing the Switches in an Equipment Rack” on page 44
ˆ “Labeling the Switches” on page 46