Allied Telesis AT-9448Ts/XP (Basic Layer 3) - Manual (Page 84)

Chapter 6: Adding and Removing Switches
84
Note
Do not issue the SAVE CONFIGURATION command. If you do, the
switch will overwrite all of the settings in the configuration file with its
current settings. If you inadvertently enter the command, download
the file again from your workstation by performing step 7.
9. To verify the new active configuration file, enter the SHOW CONFIG
command. The “Boot configuration file” field should contain the name
of the configuration file you designated in the previous step.
10. Power off the switch by disconnecting the power cord from the back
panel of the unit.
11. Go to the next procedure.
Connecting the
New Master
Switch to the
Stack
To connect the new master switch to the stack, perform the following
procedure:
1. Power off all the switches in the stack by disconnecting the power
cords from the power sources or by turning off the power circuit.
2. Cable the AT-StackXG Stacking Module on the new master switch.
For instructions, refer to “Cabling the AT-StackXG Stacking Modules”
on page 60.
3. Power on the switches of the stack, including the new master switch.
4. To verify that the new master switch is operating properly, perform the
steps in “Verifying the Installation” on page 65.
5. Install the SFP and XFP modules in the master switch. For
instructions, refer to “Installing Optional Transceivers” on page 70.
6. Connect the network cables to the ports and modules in the switch.
For instructions, refer to “Cabling the Twisted Pair and Fiber Optic
Ports” on page 74.