Allied Telesis AT-S63 - Manual (Page 492)

Chapter 25: GARP VLAN Registration Protocol
492 Section VI: Virtual LANs
Configuring GVRP
To configure GVRP, perform the following procedure:
Note
The timers in the following menus are in increments of centi seconds
which is one hundredth of a second.
To configure GVRP, perform the following procedure:
1. From the Main Menu, type 2 to select VLAN Configuration.
The VLAN Configuration menu is shown in Figure 170 on page 470.
2. From the VLAN Configuration menu, type 6 to select Configure GARP-
GVRP.
The GARP-GVRP menu is shown in Figure 179.
Figure 179. GARP-GVRP Menu
Note
Selection 8, Configure GARP-GVRP, is not shown in the VLAN
Configuration menu when the VLAN mode is multiple VLANs.
3. From the GARP-GVRP menu, type 1 to select GVRP Status.
The following prompt is displayed:
Enter your new value (E-Enabled, D-Disabled):
Allied Telesis AT-9424T/SP - AT-S63
Marketing
User: Manager 11:20:02 02-Mar-2009
GARP-GVRP
1 - GVRP Status ........... Disabled
2 - GVRP GIP Status ....... Enabled
3 - GVRP Join Timer ....... 20
4 - GVRP Leave Timer ...... 60
5 - GVRP Leave All Timer .. 1000
P - GVRP Port Parameters
O - Other GVRP Parameters
D - Reset GVRP to Defaults
R - Return to Previous Menu
Enter your selection?