Allied Telesis AT-S63 - Manual (Page 450)

Chapter 23: Multiple Spanning Tree Protocol
450 Section V: Spanning Tree Protocols
Adding, Removing, and Modifying VLAN Associations to MSTI IDs
When you create a new MSTI ID, you are given the opportunity of
associating VLANs to it. But after an MSTI ID is created, you may want to
add more VLANs to it, or perhaps remove VLANs. This procedure
explains how to associate VLANs on the switch to an existing MSTI ID and
also how to remove VLANs. Before performing this procedure, note the
following:
 You must create a MSTI ID before you can assign VLANs to it. To
create a MSTI ID, refer to “Creating, Deleting, and Modifying MSTI
IDs” on page 447.
 You can assign a VLAN to only one MSTI. By default, a VLAN, when
created, is associated with the CIST instance, which has a MSTI ID of
0.
 An MSTI can contain any number of VLANs.
This section contains the following procedures:
 ”Adding or Removing a VLAN from an MSTI ID” next
 “Associating a VLAN to an MSTI ID” on page 451
 “Removing a VLAN from an MSTI ID” on page 452
 “Associating VLANs to an MSTI ID and Deleting All Associated
VLANs” on page 453
 “Clearing VLAN to MSTI Associations” on page 454
Adding or
Removing a
VLAN from an
MSTI ID
To add or remove a VLAN from an MSTI ID, perform the following
procedure:
1. From the Main Menu, type 3 to select Spanning Tree Configuration.
The Spanning Tree Configuration menu is shown in Figure 151 on
page 416.
2. From the Spanning Tree Configuration menu, type 3 to select
Configure Active Protocol.
3. From the MSTI Configuration menu, type V to select VLAN-MSTI
Association menu.