Allied Telesis AT-S63 - Manual (Page 282)

Chapter 17: Power Over Ethernet
282 Section II: Advanced Operations
Configuring PoE Port Settings
This procedure enables and disables PoE on a port. This procedure also
sets a port’s priority level and its maximum power usage.
To configure PoE port settings, do the following:
1. From the Main Menu, type 6 to select Advanced Configuration.
2. From the Advanced Configuration menu, type 4 to select Power Over
Ethernet (PoE) Configuration menu.
The Power Over Ethernet Configuration menu is shown in Figure 109
on page 280.
3. From the Power Over Ethernet Configuration menu, type 2 to select
PoE Port Configuration.
The following prompt is displayed:
Enter port-list:
4. Enter the port you want to configure. You can specify more than one
port at a time.
The PoE Port Configuration menu is shown in Figure 111.
Figure 111. PoE Port Configuration Menu
If you are configuring multiple ports, the management software
displays the settings of the lowest numbered port.
5. To enable or disable PoE on the port, type 1 to select PoE Function
and, when prompted, type E to enable PoE or D to disable it. The
default is Enabled.
Allied Telesis AT-924T/POE - AT-S63
Production Switch
User: Manager 11:20:02 02-Jan-2009
PoE Port Configuration
Configuring PoE Port 4
1 - PoE Function ....... ENABLED
2 - Power Priority ..... LOW
3 - Power Limit ........ 15,400 mW
R - Return to Previous Menu
Enter your selection?